9" tall x 1 1/2" thick Stiletto with rhinestone ribbon accent on a 6" base.  Add any number 1-100 to celebrate a milestone occasion.

High Heel Shoe Centerpieces cut out of EPS Foam
You will receive one shoe and one base.

Choose the glitter color for the shoe and the glitter color for the base the shoe is sitting on.

The Shoe is 11" tall x 1.5" thick, on a 9" diameter base.
The centerpieces are shipped in separate pieces.
. 

High Heel Shoe Centerpieces cut out of EPS Foam. The 4" tall base is wrapped in silver rhinestone ribbon.
You will receive one shoe and one base.

Choose the glitter color for the shoe and the glitter color for the base.

The Shoe is 9" tall with a 6”x 4" tall base to sit on.
The centerpieces are shipped in separate pieces.
. 

Two-color High Heel Shoe Centerpieces cut out of EPS Foam. 

The shoe is 9" tall x 1 1/2" thick. Comes with a 6" diameter base that is 3" tall.

The first color selection is the color of the shoe.  The second color selection is for the bottom of the shoe, backside of the heel and the base.

The shoes are glittered with a loose glitter that will come off even though we brush and seal it.

The centerpieces are shipped in separate pieces for you to assemble by inserting the attached picks into the base.
. 

Cowboy Boot and Hat Glittered in your choice of colors. Add the base to make a table centerpiece.

Size - 12" tall 9" wide.  Hat and Boot are one piece.

Create your own decorations with our unfinished Party Shape foam cutout, made from 1.5" thick EPS foam. Available in 6 sizes. These shapes are ready for painting, glitter, and creative decorating to match any party theme.

Available Sizes

• 6 Inches
• 9 Inches 
• 11 Inches
• 16 Inches
• 18 Inches
• 23 Inches

The width is proportional to the height of the design.

Perfect for party decorations, table centerpieces, school projects, craft displays, and DIY events.

Foam cutouts are lightweight and self-supporting. For extra stability, we recommend inserting them into a foam base.

Decorating Tips

• Use water-based paints such as acrylic or tempera.
• For glitter application, mix paint and school glue in a 50/50 ratio, apply to the surface, and cover with glitter while wet.

Important Information

• Use water-based, non-petroleum paints and adhesives only.
• Spray paint may melt or damage EPS foam and should not be used.
• Always test new products on a small area first.
• Hot wire cut lines may be visible and can be filled with paintable latex caulk before decorating.

Attaching to a Foam Base
Insert a toothpick or bamboo skewer into the shape, remove it, add glue to the hole, and reinsert the skewer. Use same procedure for inserting it into the base.

✔ Lightweight yet sturdy
✔ Easy to paint and decorate
✔ Perfect for DIY centerpieces and party decor