Create your own custom decorations with our Unfinished Sports Foam Cutout. Each shape measures 11 inches tall, with the width proportional to the design, and is cut from 1.5" thick EPS foam.

Perfect for table centerpieces for sports banquets and all special occasions

Foam cutouts are lightweight and self-supporting. For extra stability, we recommend inserting them into a foam base.

Decorating Tips

• Use water-based paints such as acrylic or tempera.
• For glitter application, mix paint and school glue in a 50/50 ratio, apply to the surface, and cover with glitter while wet.

Important Information

• Use water-based, non-petroleum paints and adhesives only.
• Spray paint may melt or damage EPS foam and should not be used.
• Always test new products on a small area first.
• Hot wire cut lines may be visible and can be filled with paintable latex caulk before decorating.

Attaching to a Foam Base
Insert a toothpick or bamboo skewer into the shape, remove it, add glue to the hole, and reinsert the skewer. Use same procedure for inserting it into the base.

✔ Lightweight yet sturdy
✔ Easy to paint and decorate
✔ Perfect for DIY centerpieces and party decor

________________________________________

8" tall x 12" wide x 1.5" thick white EPS Foam Wrestler Cut out

You can order them unfinished for you to decorate or you can order them in glitter colors.
The items will be glittered on all sides.

Use a foam base & tooth piece to make the figure stand up

Use only water based non-petroleum products. Spray paint can eat the foam.



Use EPS Foam cut outs for a wrestler, sports party, sports teams themed party decorations.



**Disclaimer: There may be cut lines in some figures where the hot wire needed an entry & exit line to get into the center of a figure to finish cutting the shape. This line is 1/8th of an inch wide. Use paint spackle or masking tape to cover cut lines when painting &/or glittering. Spackle works better if your just painting. The glitter hides the masking tape better.